YanHua DigiMaster 3 D3 Device not found error

One of the customer reported that he got two errors when using YanHua DigiMaster 3 odometer correction tool.

Problem:

When changing odometer for Audi with D3 mileage tool, he got the “DEVICE NOT FOUND” error message, he carried on operation but to meet another error: “Obtain BIOS information fails, please re-power” (shown as picture below)

Possible reason:

Improper operation or improper shutdown the Digimaster III device which leads to the corrupt of the CPU files

Solution:

Need to re-flash CPU for Digimaster 3.

Browse to DigiMaster 3 official website:

http://www.autoemaster.com/

Download D3 Reflash SDCard rar, there is CPU re-flash instruction in the file

Reset BMW ECU to factory setting with NCS Expert software

If bimmers want to update your BMW ECU, retrofit CIC, or you have done a wrong coding/wrong setting, the best way is to bring it back to factory default settings. Here is an ECU resetting to factory settings guide with BMW ICOM engineering NCS-expert coding software.

Tool needed:

BMW ICOM ISTA-D ISTA-P with engineering software NCS Expert
BMW ICOM A2+B+C diagnostic system
A laptop running Win 7 O/S

Instruction:

1) Loading profile

Well loaded and installed BMW NCS expert software
Set up and connect BMW ICOM a2+b+c diagnostic hardware with vehicle via OBD port
Open NCS expert software
Select Expert mode
Choose Expert Mode Profile
(If you do not have Expert Mode Profile, loading the file you usually using)
Click File>>Edit Profile>>FSW/PSW

Click File-Edit Profile-FSW PSW

Uncheck the option in the red box
Click OK
Click Profile Info>>name the profile as you want
Click OK to close the Profile Editor
Click File>>Save profile as the name your precious named
Now you have a profile for loading factory settings to any ECU in the car

2) Reset ECU to factory default setting

Press F1 button
Select F3 and choose your car chassis from the list
Click OK
Press F6
Press F4
Choose the ECU your would like to code with factory default options of your car
Press OK

Choose the ECU your would like to code with factory default options of your car-2

Press F2
Choose “SG-CODIEREN”

Press F2-3

Press OK
Press F3 “Execute Job” to start coding the ECU with factory setting according to your BMW vehicle order (VO)
ECU resetting is done. Exit the NCS expert software and disconnect the BMW ICOM hardware.