Digiprog 3 V4.94 car models added and update procedure

After digiprog 3 V4.94 release at www.eobd2.fr, an increasing number of Digiprog users instantly contact the customer service asking what car models digiprog 3 V4.94 adds, what’s the procedure of the update?
Followed is my answer to the above 2 questions.

What car models digiprog 3 V4.94 adds?
Audi :
-A3 new version
Ford :
-F150 24C16
-Falcon 24c02
Mercedes :
-W176 new version
-W204 new version Diag
-W212 new version Diag
Opel :
-Insignia new version
-Astra new version
V4.93 digiprog 3 odometer programmer:

For Audi :
A3 Diag new version
A6 Diag new version
A8 Diag new version
For Mercedes :
R 172 Diag new version
R 231 Diag new version
W 212 Diag new version
For Ford :
Kuga Transit
For VW :
Amarok Polo Johnson

How to update from digiprog 3 V4.88/4.85 to 4.94?
1, Browse http://www.eobd2.fr/digiprog-3-v485-update-service.html, then pay €40.00 ($49.20),
2, Send customer service digiprog 3 serial number. Then the engineer will do update files and send you.
All files in this update package, display as follows, please confirm after you receive, otherwise it will cause digiprog Bluetooth.

Important note during update:
1), Ensure full power to the computer
2), PC standby, the screen saver is not allowed
3). Ensure stable power supply, power off during update is not allowed.
4). OS requirement: windows xp pro SP3, 32bit
5). Disable antivirus software.

The procedure of update:
1) Connect the USB to the computer,start your dp3, run Digiloader1.exe.
2) Choose the right port,select Digi1.bin,Click the button.If your dp3 dose not enter blue
screen,check your setting and restart from step 1.
3) The system will run an upgrade. The process will take 15 to 20 minutes. Do not power off during the process, otherwise you will get blue screen.
4) After the upgrade complete, the system will pops out a message reading “Process end”. Exit the update program and restart the device. The device is ready to use.

Product link:http://www.eobd2.fr/v4.94-digiprog3-odometer-master-programmer-entire-kit.html

Volvo Vida Dice Firmware update method

Copy the update exe zip file onto computer. Unzip the file and replace the name of the file SeupDiCE.xxx to SetupDiCE.exe and run the file. This file will install Dice on the computer.
FWupdate5.6.1.exe (hyperlink)
1) Connect the Vida Dice main unit into the OBD port to supply power to the unit.
2) Connect the Volvo Vida Dice with computer / laptop via USB cable
3) Open “All Programs” >> “DICE” >> “Dice Firmware Update”
4) Select Dice software version and firmware version in below program.
5) Select and open the file dice-5-6-1.mot
6) Click “Update”. Wait patiently until the procedure complete.
7) When “Device update OK!” Pops out, the upgrade procedure is complete. New firmware version information will display on the program. Click “Close”
Product link:http://www.eobd2.fr/volvo-vida-dice-diagnostic-tool-467.html